M2x2/EN M/F User Manual
iSTAT M2x2
Page 35
CT secondary
Figure 12-7
_5.0A
CT Secondary display
OK Select
Figure 12-8 shows the Device address setting structure. An underscore shows the position
of the curser. Move along by using the RIGHT or LEFT key, changes are made by
pressing either the DOWN or UP keys until the desired setting is shown, then press OK
key to confirm. The LEFT key can be pressed to return to the CT secondary setting. The
default address is 33.
Device address
Figure 12-8
_33
Device address display
OK Select
Figure 12-9 shows the Baud Rate setting structure. Changes are made by pressing either
the DOWN or UP keys until the desired setting is shown, then press OK key to confirm.
The LEFT key can be pressed to return to the Device Address setting.
Baud rate
Figure 12-9
9600 bits/s
19200 bits/s
38400 bits/s
57600 bits/s
115200 bits/s
Baud rate display
OK Select
Figure 12-0 shows the Parity setting structure. Changes are made by pressing either the
DOWN or UP keys until the desired setting is shown, then press OK key to confirm. The
LEFT key can be pressed to return to the Baud Rate setting.
Parity
Figure 12-10
No
Old
Even
Parity display
OK Select
To Next Page
Loading...