What to do if my Alto-Shaam Ranges display E-78 error?
If your Alto-Shaam Ranges unit displays error code E-78, it means the voltage is too low: below 90 VAC on a 125 VAC unit, or below 190 VAC on a 208-240 VAC unit. To resolve this, correct the voltage supply to the unit.
What does E-79 error mean on Alto-Shaam Ranges?
If your Alto-Shaam Ranges unit displays error code E-79, it indicates that the voltage is too high: over 135 VAC on a 125 VAC unit, or over 250 VAC on a 208-240 VAC unit. The solution is to correct the voltage.
What causes E-90 error on Alto-Shaam Ranges?
The E-90 error on your Alto-Shaam Ranges indicates that a button has been held down for more than 60 seconds. Adjust the control, and the error will reset once the issue is resolved.
What does E-30 mean on Alto-Shaam Ranges?
The error E-30 on your Alto-Shaam Ranges indicates that the unit has been more than 25°F (14°C) below the set point for longer than 90 minutes. In this case, the unit displays error code E-30.
What does error E-31 mean on Alto-Shaam Ranges?
The error code E-31 on your Alto-Shaam Ranges means the unit has been more than 60°F (33°C) above the maximum set-point for longer than 3 minutes. In this case, the unit displays error code E-31.
How to fix E-60 error on Alto-Shaam Ranges?
If your Alto-Shaam Ranges displays error E-60, ensure that the date and time are set correctly, if applicable to your model.
How to resolve E-dS error on Alto-Shaam Ranges?
The E-dS error on Alto-Shaam Ranges means that the Datakey digital signature is incompatible. To solve this, cycle the power and, if the error persists, install a compatible Datakey.
What does E-dT error mean on Alto-Shaam Ranges?
The error E-dT on your Alto-Shaam Ranges indicates that the installed Datakey is incompatible with the control. Install a compatible Datakey to resolve this issue.
What to do if Alto-Shaam Ranges shows dLto error?
To address the dLto error on your Alto-Shaam Ranges, cycle the power to the unit.
How to fix dLSD error on Alto-Shaam Ranges?
To fix the dLSD error on your Alto-Shaam Ranges, plug in the SD card and cycle the power.
General| Model | CC-48 |
|---|---|
| Brand | Alto-Shaam |
| Category | Oven |
| Type | Cook & Hold Oven |
| Power Source | Electric |
| Construction | Stainless Steel |
| Interior Material | Stainless Steel |
| Exterior Material | Stainless Steel |
| Control Type | Digital |
| Humidity Control | Yes |
| Cook & Hold | Yes |
| Halo Heat Technology | Yes |
| Power Supply | 208/240V |
| Width | 48" (1219mm) |
| Warranty | 1 Year |
To Next Page