MN-29756 (Rev. 5) 12/17 • TH-SK Series Cook, Hold, Smoke •
Operation
This appliance is intended for use in commercial
establishments by qualied operating personnel where
all operators are familiar with the purpose, limitations,
and associated hazards of this appliance. Operating
instructions and warnings must be read and understood
by all operators and users.
Start-Up Operation
Before initial use or after removing the
appliance from storage:
1. Remove all packing material from the appliance.
2. Remove and wash any detachable items such as
wire shelves, side racks, pans, and drip pans with
hot, soapy water. Dry with a clean damp lint-free
cloth.
3. Remove all visible grease or oil from the appliance.
4. Clean the interior and exterior of the appliance
with a mild soap and water solution. Apply the
solution with a clean damp cloth. Do not use
commercial or household cleaners that contain
ammonia. Wipe with a clean, damp cloth to
remove all detergent residue. Dry with a clean,
lint-free cloth.
5. Clean the appliance glass with glass cleaner or
distilled vinegar.
6. Install the side racks and wire shelves - position
shelves with the curved end up and toward the
rear of the appliance. Re-install drip pan.
7. Operate the oven without food for a period of
two (2) hours at a temperature of 300°F (149°C) to
remove surface oils and any accompanying odor.
The appliance is now ready for operation.
Fahrenheit (°F) / Celsius (°C):
The factory default is Fahrenheit. To change to Celsius:
1. Press and hold the Temperature Display button
and the Down Arrow key for 5 seconds.
2. The control will show
.
C
for 3 seconds to verify
selection and then show the temperature in ºC.
3. Repeat to toggle to Fahrenheit.
Press the Temperature Display button at any time to
display the alternate temperature.
NOTICE: With a power failure, factory test, etc., the
control will retain the ºC or ºF setting selected
by the user when power is restored.
To prevent personal injury or
propertydamage:
Always use hand protection when
operating this appliance to avoid burns.
Metal parts of this equipment become
extremely hot when in operation.
To prevent serious personal injury, death, or
property damage:
Do not steam clean, hose down or flood the
interior or exterior with water or liquid solution
of any kind. Do not use water jet toclean. Failure
to observe this precaution will void the warranty.
To Next Page
Loading...
Need help?
General
