INSTALLATION
Converge® ▪ Operator’s Manual ▪ MN-47239 ▪ Rev 3 ▪ 5/23
43
Continued from previous page
9. Rotate the rack and lower it into the slots on the shelf.
Attach the rack to the shelf with cotter pins.
10. Repeat the process for the other rack.
Installing the
support channels
11. Locate the holes in the top of the stand with the letter “C” etched next to
them.
Continued on next page
NOTE: Expand the cotter pin after inserting it through
the hole.
To Next Page
Loading...
