MAINTENANCE
Converge® ▪ Operator’s Manual ▪ MN-47239 ▪ Rev 3 ▪ 5/23
98
Continued from previous page
2. Touch the “Cleaning” icon 0. The “Cleaning” screen displays.
3. Select the desired cleaning level, for example “Light Clean” 1.
Distribute the cleaning tablets equally between the chambers. Place
tablets on the jet plates.
Touch the start icon 2.
4. The oven heats to the required temperature for the cleaning cycle, then the
cleaning cycle starts.
Continued on next page
NOTE: Touching the cancel icon “X” cancels the cleaning
cycle. The oven will start a forced rinse. The forced rinse
must complete before operating the oven.
To Next Page
Loading...
