14
(4.4) Using the Aux Input
Connect your smartphone, MP3
player, or similar device to the Aux
Input. Adjust the output volume on
your source device and then adjust
the overall volume using the Channel
3 Volume Control on Busker.
(4.5) Speaker Use Controls
Press the Speaker Use button to cycle
through the different presets listed below.
This will adjust the DSP to the desired
setting.
• With Sub: The speaker is positioned
upright or horizontal on the ground (or
other flat surface) facing the audience.
• Pole: The speaker is elevated on a
speaker stand around ear level facing
the audience.
• Monitor: The speaker is positioned
horizontal on the ground facing the
performer.
• Via App: This is the custom EQ setting
selected from the ALTO Pro App. The
default setting is flat.
Press and hold the Speaker Use button for 3 seconds to activate Volume Display
Mode. Volume levels for each channel will be seen from the Speaker Use LED
indicators. A channel’s SIG/LIMIT LED will flash to show the active channel. When
the LED is lit red, it represents the channel volume. When the LED is lit green, it
represents the FX level. The volume will also be displayed when a channel’s volume
knob is adjusted.
The Volume Display Mode will automatically exit after 20 seconds
of no use. Alternatively, press and hold the Speaker Use button for 3 seconds to
exit.
Press to cycle through presets.
Press and hold for 3 seconds to enter Volume
Display Mode.
To Next Page
Loading...
