17
If the unit is not charging: Make sure the power cable is properly connected to the
power input and the power outlet.
If the sound is distorted: Try lowering the volume control of your sound source,
musical instrument, or microphone. Also, try to reduce the overall volume of Busker
using the Main Volume knob.
I hear a hum when cables are connected:
• Disconnect cables from the input jacks to see if it’s a faulty cable.
• Use balanced cabling connections whenever possible.
• Make sure the signal cables are not placed near power cables.
• Connect all audio equipment power cables to outlets which share a common
ground.
If there is too much bass: Try adjusting the tone or EQ control on your sound
source to lower the bass level. This will allow you to play the music louder before
clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If you can’t hear the microphone over the music volume: Turn down the music
volume from your source.
If you can't hear your instrument: Check that the INST/LINE switch is set to INST.
If you can’t play music from a flash drive: The USB port is only for charging USB
devices.
(5.0) TROUBLESHOOTING
To Next Page
Loading...
