Alto SSB 430 - Cleaning Agents Guide

38
1
1
0
1
2
3
4
5
4. Raise suction nozzle using
lever (1).
5. Allow suction unit to run for
an additional 3 minutes with
tank lid open. Dry ambient
air increases service life.
6. Move „suction unit“ switch to
OFF.
7. Disconnect mains/battery
plug.
6.2 Emptying and cleaning
dirty water tank
1. Empty dirty water via drain
hose (1).
2. Flush out dirty water tank
with clean water (max.
40ºC).
3. Firmly close drain hose after
emptying and hook into
bracket.
6.3 Emptying and cleaning
fresh water tank
1. Empty fresh water tank
using drain tap (SSE 430
only).
2. Flush out fresh water tank
with clean water (max.
40ºC).
3. Close drain tap after
emptying.
6.4 Cleaning suction
nozzles
1. Check suction nozzle wiper
lips for contamination (paper,
cigarette ends, sand etc.)
2. Clean wiper lips with water
and cloth.