34
1
0
1
2
3
4
5
1
1
4
2
3
4 Control/Operation
4.1 Brushing and
vacuuming
1. SSB 430: Battery should be
fully charged.
SSE 430: Connect to power
supply.
2. Lower suction nozzle using
lever (1).
3. Set fresh water metering
rate using metering lever (1).
Swivel lever to position 4 =
max. metering rate. Swivel
lever to position 1 = min.
metering rate.
4. Move „cleaning agent
supply“ switch (1) to ON.
Supply is ready for
operation, but cleaning agent
does not flow until hand
switch (4) is operated.
5. Move „suction unit“ (2)
switch to ON. Suction unit
begins to operate.
6. Press release switch (3) and
operate hand switch (4).
Brush begins to rotate and
cleaning agent flows to
brush.
7. Automatic cleaning machine
is moved by pushing.
8. Forward movement is
assisted by disk brush
rotation.
To Next Page
Loading...
