31
1
2
1
ç
ç
3.3 Attaching the suction
nozzle
1. Insert suction nozzle into
rotating fork.
2. Red suction lip at front.
3. Attach suction nozzle by
turning the quick-locking
lever (1) clockwise.
4. Push suction hose onto
suction nozzle fitting.
Adjust suction nozzle angle to
suit type of floor surface:
6. Unscrew knurled nut (1)
away from adjusting screw.
7. Turn adjusting screw (2) until
required angle has been
reached.
8. Screw knurled nut up
against adjusting screw.
3.4 SSB 430
Inserting and
connecting battery
CAUTION!
Risk of electric shock!
Do not place tools or other
parts on battery or battery
terminals and do not touch
with wet hands.
WARNING!
The fresh water and dirty water
tanks must not contain any
water.
1. Move „cleaning agent
supply“ and „suction unit“
switches to OFF.
2. Observe battery handling
instructions (chapter 7.3).
3. Slacken locking clamps and
swivel up dirty water tank.
4. Insert batteries into battery
compartment.
( = direction of travel)
5. Connect terminals as shown
in connecting plan.
6. Attach connectors.
7. Swivel down dirty water
tank.
8. Close locking clamps.
To Next Page
Loading...
