32
1
2
1
2
3.5 SSE 430
Electrical connection
1. Move „cleaning agent
supply“ and „suction unit“
switches to OFF.
2. Pull loop of extension cable
(20m) through ring and
attach to strain relief (1).
3. Insert machine plug into plug
socket (2).
4. Connect mains plug to
mains socket, ensuring that
voltage indicated on rating
plate of machine matches
mains voltage.
3.6 Fitting the brush 1. Place brush on floor in
working position.
2. Tilt machine to rear and
drive over brush.
3. Move machine backwards
and forwards slightly until
brush is audibly centred.
4. Press release switch (1) and
briefly operate hand switch
(2).
5. Brush drive rotates.
6. Brush engages audibly.
7. Release hand switch. Brush
motor switches off.
To Next Page
Loading...
