2
6
8
8
Carefully read all instructions for the installation prior
to installing unit. Make sure each step or procedure is
understood and any special considerations are taken into
account before starting installation. Assemble all tools,
hardware and supplies needed to complete the installa-
tion. Some items may need to be purchased locally. After
deciding where to install unit, closely look the location
over – both the inside and outside of the home. Note any
potential obstacles or problems that might be encountered
as noted in this manual. Choose a more suitable location if
necessary.
IMPORTANT NOTE: IF A CRANKCASE HEATER IS
USED, THE UNIT SHOULD BE ENERGIZED 24 HOURS
PRIOR TO COMPRESSOR START UP TO ENSURE
CRANKCASE HEATER HAS SUFFICIENTLY WARMED
THE COMPRESSOR. COMPRESSOR DAMAGE MAY
OCCUR IF THIS STEP IS NOT FOLLOWED.
Before using this manual, check the serial plate for proper
model identication.
The installation and servicing of this equipment must be
performed by qualied, experienced technicians only.
To Next Page
Loading...
Need help?
General