3
Upon receiving the unit, inspect it for damage from
shipment. Claims for damage, either shipping or
concealed, should be led immediately with the shipping
company. Check the unit model number, specications,
electrical characteristics, and accessories to determine if
they are correct. In the event an incorrect unit is shipped,
it must be returned to the supplier and must NOT be
installed. The manufacturer assumes no responsibility for
installation of incorrectly shipped units.
These instructions are addressed primarily to the installer;
however, useful maintenance information is included and
should be kept, after installation, for future reference.
When reporting shortages or damages, or ordering repair
parts, give the complete unit model and serial numbers
as stamped on the unit’s nameplate. Replacement parts
for this appliance are available through your contractor or
local distributor. For the location of your nearest distributor,
consult the white business pages, the yellow page section
of the local telephone book or contact:
The following symbols and labels are used throughout this
manual to indicate immediate or potential hazards. It is the
owner’s responsibility to read and comply with all safety
information and instructions accompanying these symbols.
Failure to heed safety information increases the risk of
serious personal injury or death, property damage and/or
product damage.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
The APHM5 SEER2 M-Series heat pumps are designed
for OUTDOOR USE ONLY. APHM5 SEER2 M-Series
is available in cooling capacities of 2, 2.5, 3, 3.5 and 4
nominal tons of cooling. Optional eld-installed heat kits
are available in 5, 8, 10, 15 and 20kW. The units can be
easily installed in manufactured or modular homes with
existing high-static duct work. The units can also be easily
converted to accommodate a plenum for normal or low-
static applications. The APHM5 SEER2 M-Series are
self-contained packaged units so the only connections
needed for installation are the supply and return ducts, the
line and low voltage wiring and drain connection. Rated
performance is achieved after 20 hours of operation.
Rated performance is delivered at the specied airow.
See product specication for packaged models.
Specication sheets can be found at:
www.goodmanmfg.com for Goodman® brand products or
www.amana-hac.com for Amana® brand products. Within
either website, please select the residential or commercial
products menu and then select the submenu for the type
of product to be installed, such as air conditioners or heat
pumps, to access a list of product pages that each contain
links to the model’s specication sheet. The units are ETL
listed, and AHRI certied. The information on the rating
plate is in compliance with the FTC & DOE rating for single
phase units.
To Next Page
Loading...
Need help?
General