15 RS2230003 Rev. 1
Operation
Operating Preprogrammed Pads
Equipment has 2 menus with 10 preprogrammed number
pads.
1. Open oven door, place food in oven, and close oven
door.
• Display shows “b” or “d” and “READY”.
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press
MENU b/d
pad to select preprogrammed menu.
• “b” or “d” shows in display.
3. Press desired number pad.
• Oven operates and time counts down.
• Display shows heating time, “POWER”, ”COOK
LEVEL”.
• Display shows “POWER” only when microwave
energy is present.
• If power level other than 100 percent power was
programmed, display shows “COOK LEVEL” and
power level. Display counts down cooking time.
• If additional heating time is required, press
preprogrammed pads before or after heating cycle
ends.
4. Oven stops heating and oven signal sounds when
heating timing elapses.
Power-up Display
After equipment is plugged in, display shows 4 large
dashes and 1 small dash. Open and close oven door to
clear display and activate pads.
Interrupting Operation
• Open oven door to interrupt operation. Oven fan
continues to operate. Close door and press
START
pad to resume oven operation.
• Press
STOP/RESET
pad to interrupt operation.
Display continues to show countdown time. Press
START
pad to resume oven operation and countdown
timing.
Canceling Mistakes
• If oven is not operating, press
STOP/RESET
pad to
clear display.
• If oven is operating, press
STOP/RESET
pad once to
stop oven, then again to clear display.
• If oven door is open and time shows in display, close
oven door and press
STOP/RESET
pad to clear
display.
Preprogrammed Times and Cook Level
All preprogrammed pads arrive set at full power. Menus
“b” and “d” are programmed identically at factory.
Pads Heating Times
110 seconds
220 seconds
330 seconds
445 seconds
51 minute
6 1 minute 30 seconds
72 minutes
83 minutes
94 minutes
05 minutes
To Next Page
Loading...
Need help?
General
