Version 1.5 ©Copyright 2017, Ambient LLC. All Rights Reserved. Page 11
Make sure the remote sensor LCD display is working
and the transmitter light is flashing once per 60 seconds.
Install a fresh set of batteries in the remote thermometer.
For cold water environments, install lithium batteries.
Make sure the remote sensors are not transmitting
through solid metal (acts as an RF shield), or earth
barrier (down a hill).
Move the display console around electrical noise
generating devices, such as computers, TVs and other
wireless transmitters or receivers.
Use the tether to fix the sensor as close as possible to the
console.
Pool float does not power up.
If the display does not power up after inserting the
batteries, press the reset button shown in Figure 4.
If your pool float does not include a reset button, cover
the solar panel with one hand, remove the batteries, wait
60 seconds, reinsert the batteries, and uncover the solar
panel.
LCD display fading or unreadable.
Replace batteries in the floating thermometer.
Extreme heat or cold will cause the display to fade but
does not affect the wireless functionality. Bring into
house to restore display.
8 Accessories
The following software and hardware accessories are available for this weather station at
www.AmbientWeather.com .
Additional float thermometers. Console supports up to 8 channels.
Wireless thermometer. Consoles support up to 8 channels.
Wireless thermometer-hygrometer. WS-07, WS-08 supports up to 8
channels.
Wireless temperature probe. Consoles support up to 8 channels.
Ambient Weather WS-07 Big Digit 8-Channel Wireless
Thermo-Hygrometer Console. Add as many consoles as you like.
Ambient Weather WS-08 Wireless Indoor/Outdoor 8-Channel
Thermo-Hygrometer with Daily Min/Max Display Console. Add as
many consoles as you like.
Ambient Weather WS-09 8-Channel Wireless Refrigerator/Freezer
Thermometer console. Add as many consoles as you like.
To Next Page
Loading...
Need help?
General
