Version 1.0 ©Copyright 2020, Ambient LLC. All Rights Reserved. Page 7
On the Sensors ID screen, you can register or re-register an additional sensor by clicking the Re-register button.
Note: the console receives and sends this data directly to AmbientWeather.net. The data is not displayed on the
console (pass through only) and cannot be calibrated.
5. Glossary of Terms
Accuracy is defined as the ability of a measurement to match the actual
value of the quantity being measured.
Range is defined as the amount or extent a value can be measured.
6. Specifications
6.1 Measurement Specifications
5.2 Wireless Specifications
• Line of sight wireless transmission (in open air): 150 feet, 100 feet under most conditions.
• Frequency: 915 MHz
• Update Rate:
Temperature update interval: based on channel selection
5.3 Power Consumption
• Sensor: Internal AA, sealed alkaline battery (non-replaceable)
• Battery life: 24-36 months with regular use (extended the battery life by turning unit off when not in use)
• Extend battery life by turning off the sensor when not in use by pressing and holding the button on the bottom of
the unit for 10 seconds. Power the sensor up again by pressing and holding the button for 3-5 seconds.
• When the WH31PF battery finally dies you can purchase a replacement floating pool/spa sensor here:
https://ambientweather.com/wh31pf-wireless-waterproof-floating-thermometer
7. Troubleshooting Guide
If your question is not answered here, you can contact us as follows:
• Email Support: support@ambientweather.com Technical Support: 480-346-3380 (M-F 8am to 3pm Arizona Time)
Wireless remote (floating thermometer)
not reporting into console.
The maximum line of sight communication range is 150’
and 100’ under most conditions. Move the sensor closer
to the display console.
To Next Page
Loading...
Need help?
General
