Click on the appropriate button and select from drop down list and optionally rename it. Currently,
support is limited to ARRI ALEXA Classic line (ALEXA SXT and ALEXA Mini are not supported yet), RED
DSMC 1 & 2 based cameras, and Sound Devicers’ 788T and 6 series audio recorders. On ARRI ALEXA
you will need to enter the last 4 digits of the serial number found on the top-mounted plate or within
the camera’s system menu.
This will also require special cables to physically link MasterLockit to the respective device, please refer
to chapter 14. for comprehensive listing of available options.
Note: The name assigned on a Slave does not synchronize with the names in the ACN Radar of a Master.
It is advised to duplicate the naming there.
On physical connection the device will now show up active and green on the “Local MasterLockit”
frame.
Note: When connected to a supported audio recorder you can access the “Remote Control” subpage
which will offer extensive access for remote rec roll, take history metadata editing, and sound report
export. This is the same as the “Sound Recorder” menu available through tab or burger menu. See next
chapter.
Other Lockits on ACN Channel XX:
All Lockit devices in C-Jam mode on the same ACN channel in range will automatically appear in this
section. A green header indicates there is an active connection through ACN while a grey header
indicates a unit is offline. You may also rename connected units for better identification.
Note: The hub will list all Lockits ever logged in. Remove any units that are not or no longer in your
active setup by clicking on the trash can.
Timecode frame rate must be consistent on all units on a set. Full Jam will automatically take care of
this on initial jam with the only exception being Lockits with enabled video sync. Still, you can easily
check these units and make changes accordingly. You may also rename the Lockits for clear
identification to ease battery monitoring.
Note: If known present units do not show up, check the Master is actively broadcasting C-Jam and ACN
channel is consistent on all units.
To Next Page
Loading...
