Sync menu only available on ACL204 Lockit and ACN-TL TinyLockit (“Extended”), Slate Menu only on
ACN-LS LockitSlate
To open the Main Menu press the 3-directional configuration wheel in home screen, navigate by
toggling left/right. Menus are rotational, so you can go from the first to the last setting by moving left.
Pressing the highlighted selection will open its submenu, pressing the arrow up/house symbol will take
you back again. When there is no further submenu the current active setting will be highlighted. If you
do not want to apply changes just press on the highlighted selection and you will fall back to main
menu without alterations.
Mode Menu
Selecting the operation Mode will allow for one step configuration when initializing your Lockits for a
new project. Just pick your application and all necessary adjustments will be performed automatically
under the hood. Together with the “Full” Jam mode and auto frame rate setting there is hardly anything
left to do but choose your sync option on ACL204 if applicable and Jam sync your units via cable or ACN
after having put one unit into C-Jam Master mode. Each mode has a dedicated LED blink code of the
two colored LEDs above the OLED display, which will also show selected mode and active transmission
direction.
“Int TC”: “Classic” Lockit mode without ACN enhancements. The unit will run on its internal generator
with standalone accuracy of .1ppm.
“C-Jam”: Same as “Int TC” but with ACN features enabled. This is the default and recommended setting
when running any combination of ACN ready units. The devices can wirelessly be jammed and TC
framerate applied, and metadata transferred to a MasterLockit. Additionally the units will automatically
adopt their pace to a “Master” unit for unprecedented zero drift accuracy and divergence down to
10uS.
To Next Page
Loading...
