“Extended” will disclose all available options and allow for the most complex configurations to suffice
even the most avid TC and Sync Supervisor.
E.g. this mode will unlock more uncommon sync and TC formats such as of PAL and NTSC SD, 720P at
30 or 60 fps, variable word clock and black audio, PPF, sync output for 3D rigs, and applying an Offset to
the TC output for compensation of frame processing delay. Clearly, these are options not required for
most applications and there will be hardly reason to unleash this level.
Note: Settings are persistent through a level change which allows you to start off with guided default
depth and tweak in “Extended” if required.
The menu description below will use these conventions:
Underlined: marks a (sub) menu, pressing the navigation wheel will open the next lower level, which
may contain submenus or parameters.
“Quoted Italic”: marks a parameter setting. This is the lowest level of a menu. Depending on the
available options these will be listed visible or can be scrolled (separated by “/” in the explanation
below). Active values will be highlighted. To change use the navigation wheel to select and press to
apply, to keep current settings just press. Both will automatically jump up one menu level with “Home”
selected. So, intentionally or accidentally, you will always quickly find your way back home.
Bold: marks the factory default setting of a parameter, the unit will load these values on performing a
Sys/Reset.
(E): Only available when “Extended” is selected in Sys/Menu.
Some menus, parameters, or settings will also be exclusive to different devices and marked accordingly
(1) ACL204 Lockit, (2) ACN-TL TinyLockit, (3) ACN-LS LockitSlate, (4) ACN-ML(P) MasterLockit(Plus)
To Next Page
Loading...
