Defines the level depth and sophistication of available options.
“Lock” prevents unwanted alterations to the settings. It is recommended to lock the unit after
configuration. To unlock you will be prompted to hold the configuration wheel left for 3 seconds after
which a unlock message will appear.
Note: Due to the power logic on ACN-TL, ACN-LS, and ACN-ML, this message will also pop up when
shutting down these units with the required long press to the configuration wheel. It is however not
necessary to unlock the menu to power down. Just keep the button pressed for 3 seconds and the unit
will shut down as desired.
“Standard” will only show valid settings that have proven practical for the majority of productions, so
we highly recommend leaving it sitting here unless you run in apparent limitations to your required
configuration.
“Extended” gives you all available configuration options. This mode will unlock sync output for 3D rigs,
more uncommon video and TC rates of 30 and 60 fps, PAL and NTSC SD sync. Additional options
include enhanced Audio and PPF sync options, apply an Offset to the TC output for compensation of
frame processing delay.
Config
To Next Page
Loading...
