Defines the slate displaying on clap. Successively apply 0 to 20 seconds for Userbits, Clapped TC and
Running generator TC. Selecting a time will automatically move on to the next parameter and the
selected value will display in the line above, led by the parameter indicator (“UB”, “CT”, “TC”).
LEDs
Configures the flash LEDs on front.
“Clap” will light up the 2 bright LEDs only when the slate is operated, allowing for clear identification of
the slated frame.
“Clap+Seconds” also flashes LEDs on every second transition.
“Off” defeats the flash LEDs.
Sensor
Adjusts Tilt and Brightness sensors
Tilt “On/Off” enabling will revert the 7 digit display when the slate is operated upside down for special
markers like end slate e.g.
Brightness, choose between “Man”, “Low”, “Medium” and “High”.
“Manual” lets you adjust the display brightness in 9 steps during operation by flicking the 3-function
wheel. Looking from the back, flicking left will de- and moving right increase brightness.
“Low” enables the environment light sensor with a dim setting usefull for late night shoots. Still, when
light falls on the slate it will increase brightness for better reading and dim down to not interfere with
the shoot.
“Med” is automatic dimming with maximum medium brightness.
“High” is applicable for outdoor shoots in bright light but still with a concern about battery life.
To Next Page
Loading...
