Ametek Drexelbrook ThePoint Series - 2.9 Sensing Element Connection (Remote)

Installation
13
2.9 Sensing Element Connection (continued)
For ThePoint instruments mounted remotely from sensing
element, cable connections from sensing element to Electronic
Unit are made to terminals beneath the Electronic Unit. See
Figure 2-8.
Figure 2-8
Sensing Element Connection
(Remote Housing)
GROUND
(GREEN)
COTE-SHIELD
(RED)
CENTER WIRE
(BLUE)
REMOVE
ELECTRONIC
UNIT TO ACCESS
SENSOR HARNESS
(2.5mm Hex-Head Screws)
Cable Fitting
(M20 AdapterOptional)
EQUIPOTENTIAL
TERMINAL
+
SHIELD WIRE MUST BE CLIPPED BY USER
CLIPPED SHIELD WIRE MUST NOT TOUCH CONDULET HOUSING
2 TERMINAL PROBE (TYP)
3 TERMINAL PROBE (TYP)
Ground Wire
(GREEN)
Ground Wire
(GREEN)
Center Wire
(BLUE)
Shield Wire
(CLIPPED)
Center Wire
(BLUE)
Shield Wire
(RED)