Part File Information.
This information can be used to keep track of
Part Number, Description, Order Number,
Comments, etc., related to this file.
These headings will appear on
printouts
. The software will default to PART#,
you can add additional lines, up to ten, by clicking on the + icon. Type in the Name, Value can be added later.
High light the line and click on the “Waste-Can” to delete lines
.
Data entry is not required.
Select OK when done.
Clicking on the checkbox for “Prompted” will cause this window to appear after each test so the operator can enter relevant
data.
Selecting "Sort by Prompt" will sort data in the printouts by the prompts so commented data can be readily identified.
.
To Next Page
Loading...
