Ametek TR-2100 - Configuration Switches

TR-2100 User Manual 29
4 Hardware Configuration
The TR-2100 is available in many configurations with various user defined options. The
values set for this machine at time of delivery can be found on the User Specification sheet
and the System Drawings in Appendix V of this manual. The TR-2100 hardware
configuration is set through two sets of 8 DIP switches on the acquisition board. The first
bank (SW1) is the left hand of the two switch banks. It has the following functions:
Table 1 Table 2
* Default setting
Switch Function Off On
1 Digital-only cards Yes No
2 System frequency 50 Hz 60 Hz
3 No. of analogue cards – 1 See Table 2
4 No. of analogue cards – 2
5 Cross triggering Disable Enable
6 GPS receiver Yes No
7 Time code port Master Slave
8 (undefined)
Switch 3 Switch 4 Analogue
Input Boards
Off Off 1
Off On 2
On Off 3
On On 4
The second bank (SW2) is the right one of the two banks. The functions of these switches
may be altered. They have the following functions:
Table 3 Table 4
Table 5
Switch 2 Switch 3 Baud Rate
Off Off 1
Off On 2
On Off 3
On On 4
Switch Function Off On
1 Time code port Disable Enable
2
3
Program port – baud rate See Table 4
4 Printer No Yes
5 Modem No Yes
6 Synchrophaser on rear
COMM
No Yes
7 No. of digital only cards -
1
8 No. of digital only cards -
2
See Table 5
Switch 7 Switch 8 Digital Input
Boards
Off Off 1
Off On 2
On Off 3
On On 4