Ametek TR-2100 - Hardware Settings

TR-2100 User Manual 46
Hardware Settings
Acquisition Board Configuration Switches
Set-up the acquisition board configuration switches as shown below. Reference the System
Drawings for number of channels and options to be enabled.
Bank 1
Table 7 Table 8
* Default setting
Switch Function Off On
1 Digital-only cards Yes No
2 System frequency 50 Hz 60 Hz
3 No. of analogue cards – 1
4 No. of analogue cards – 2
See 8
5 Cross triggering Disable Enable
6 GPS receiver Yes No
7 Time code port Master Slave
8 (undefined)
Switch 3 Switch 4 Analogue Input
Boards
Off Off 1
Off On 2
On Off 3
On On 4
Bank 2
Table 9 Table 10
Table 11
Switch 2 Switch 3 Baud Rate
Off Off 1
Off On 2
On Off 3
On On 4
Switch Function Off On
1 Time code port Disable Enable
2
3
Program port – baud rate See 10
4 Printer No Yes
5 Modem No Yes
6 Synchrophaser on rear
COMM
No Yes
7 No. of digital only cards -
1
8 No. of digital only cards -
2
See 11
Switch 7 Switch 8 Digital Input
Boards
Off Off 1
Off On 2
On Off 3
On On 4