TR-2100 User Manual 50
Hard Drive Format Procedure
The TR-
2100 has an internal CLI program that will allow you to format the system’s internal hard
drive. This will require the use of a Terminal program (such as Win95’s HyperTerminal,
Qmodem, Telix, ProComm Plus, etc.) that can send data in ASCII format.
WARNING!
Only authorized personnel with computer service experience should
perform this procedure. Contact the factory if there are any
RECOMMENDED EQUIPMENT LIST:
1. Computer with:
- MS Windows™ 95 or better
- Display Station32
- HyperTerminal or equivalent
- Unused 9 pin RS-232 port
2. TR-2100 direct connect cable
3. TR-2100 User Manual
4. Display Station32 Instruction Manual
IMPORTANT NOTE: The TR-2100 Event Directory will be deleted. Before beginning the
hard drive format procedure, retrieve all events, harmonic files, and trend logger files.
Setting Up the Terminal Program
The TR-2100 Local RS-232 port can be set for 57600 or 11500 baud by switch SW2-3 on
the master acquisition module. If the switch is off, the Local RS-232 port is set for 57600
baud. If the switch is on, the port is then set for 57600 baud. The factory default is 57600.
HyperTerminal™ is a Terminal program that comes standard with Win95 (or higher);
therefore, this procedure will reference it. If you decide to use another Terminal program,
use the following parameters: 57600 baud (or as needed, see above), no parity (N), eight
data bits (8), one stop bit (1), and Hardware Flow control (Software Flow control is not
used).
To Next Page
Loading...