TR-2100 User Manual 56
Installing NE2000 Compliant Network Cards
1. Make sure you have the appropriate network connectors available at the back
panel of the TR-2100 unit, depending whether you need RJ-45 or Coaxial. If you
don’t see what you need on the back panel, it is recommended that you call
Ametek Technical Support.
2. The network card must first be installed in a PC to be setup. It is recommended
that the PC not already have a network card installed. You will need to run the
Setup program for the network card, which is usually found on the accompanying
diskette packaged with the Network card.
3. Once you have the Setup program on the screen, set up the network card for both
coaxial and twisted pair. Next set the IRQ for 11 and Hex address for 360.
4. Save the setup information and the card is ready to install in the TR-2100.
Remove the card from the PC.
5. To install the Network card, you will need to remove the left white vertical
bracket, one screw holds it in place. To locate this bracket, open the front panel
and look on the internal left hand side of the case.
6. Once the bracket is removed, the network card must be installed in one of the
two bottom slots. Make sure to remove the retaining screw at the top of the
chosen slot, before installing the Network card. Install the card in the slot, and
then replace the retaining screw to hold the Network card in place.
7. Before re-installing the left white vertical bracket, make sure to plug in your
coaxial or RJ-45 connector, and then replace the bracket.
To Next Page
Loading...