TR-2100 User Manual 54
PC conflict, or a failed port. Please call Technical Support for additional
information or help.
14. Now you will perform the following command to format the Hard drive. At
the CLI> prompt, type in system formatdisk and press the Enter key.
Formatting will take 30 minutes or longer to complete. See the example
below. Once the process is complete, a message will appear telling you that
the format was successful.
Example: CLI>system formatdisk
15. At the CLI> prompt type in the word Q
UIT and press the enter key. The
recorder will respond that it has disconnected. Exit (close) your Terminal
program now. Do not just minimize the program.
16. The rest of this procedure is not mandatory, but should be followed to make
sure the unit is working correctly. Start DS32 and establish a connection to
the TR-2100. Go into the Configuration window. The program may prompt
you to update the Recorder or Local configuration (next screen). Select
“Update the RECORDER configuration”.
To Next Page
Loading...