Ametek VERSITRON BT130S - Page 17

Versitron Operation Manual 17
Rear Connections
Attach all the connections at the back of the test head. They are all in labeled
positions. Each connection is keyed so that only the proper male and female ends will
fit. Attach the power cable and plug it into the power source. Attach the preload switch
cable from the bottom of the test head. Attach a USB cable (optional) to a data
collection computer, running DataView.
Power Switch
AC Power In
AC Power Out To Motor
(Motorized)
Motor Control
(
Motorized
)
Sensor
(
Motorized
)
DataView Output
(Op
tional
)
Installing the Test Head
Load Plate
Pressure Yoke
Preload Switch
USB Port