2 Versitron Operation Manual
TRADEMARKS
AMETEK is a registered trademark of
AMETEK, Inc. NEWAGE TESTING
INSTRUMENTS is a trademark of
AMETEK, Inc. Other trademarks are the
property of their respective owners.
SUPPORT
AMETEK Newage Testing Instruments,
Inc.
820 Pennsylvania Blvd
Feasterville PA 19053
USA
Tel: (215) 355-6900
Fax: (215) 354-1803
newage.info@ametek.com
AMETEK Measurement and Calibration
Technologies
8600 Somerset Drive
Largo, FL 33773
USA
Tel: +1 (727) 536 7831
Tel: +1-800-527-9999 (within USA only)
www.hardnesstesters.com
CAUTION!
HIGH FORCES ARE OFTEN INVOLVED
WITH THE HARDNESS TESTING
PROCESSES.
The machine is powered by mains supply
voltage
The machine is a Class 1 product, which
means it MUST be connected to a mains
socket outlet with a PROTECTIVE
EARTH CONNECTION
Do not position the equipment so that it is
difficult to operate the mains disconnect
device (machine mains inlet socket).
If the equipment is used in a manner not
specified by the manufacturer, the
protection provided by the equipment
may be impaired
To maintain all aspects of the
specification, only Newage approved
accessories connections and
components should be used
Strictly adhere to all specified safety
procedures
PLEASE READ THIS MANUAL
BEFORE USING THE HARDNESS
TESTING MACHINE.
To Next Page
Loading...
