Amiga 1000 - Ram Expansion

AMIGA
1000
ASSEMBLY
LEVEL
REPAIR
1.10 RAM
EXPANSION
TEST
1.10.1
Turn
system OFF.
1.10.2 Remove
RAM
EXPANSION COVER from front
of computer.
1.10.3
insert RAM
EXPANSION CARTRIDGE
A1050.
Install the
cartridge
straight onto the card edge
connector.
Be
certain it is
secure.
1.10.4 Replace
RAM
EXPANSION COVER.
1.10.5
Power ON.
1.10.6
Insert the
diskette
labeled
KICKSTART
into the
internal
drive.
At
this time, the
screen
should turn white as the
system
loads the
disk. The
drive
activity
light will flash
briefly and the
drive access sounds
should be
heard. After
approximately
30
seconds and
some screen
changes, the system
should
display a
hand
holding a diskette
labeled WORKBENCH.
•
If the
hand holding the
diskette
labeled
KICKSTART
REAPPEARS,
re-seat
the diskette
and
RETRY.
If after 3
or 4 retries,
the
system
stili does
not
accept the
KICKSTART
diskette, try
a
DIFFERENT COPY
of the disk.
•
If
the
disk still
WILL NOT LOAD,
refer to 1.7
DRIVE
ASSEMBLY
CHECK
OR
•
If the
drive was
previously tested as
OK, EXCHANGE
the
RAM
EXPANSION
CARTRIDGE
and
RETRY.
1.10.7
Remove the
KICKSTART
disk.
1.10.8
Insert the diskette
labeled
WORKBENCH into the
internal
drive.
At this
time, the
screen will
turn white for
approximately 2
seconds
and then
display the
boot-up message
while continuing to
load from the
disk.
•
If
the
hand
holding the
diskette
labeled
WORKBENCH
REAPPEARS,
re-seat the
diskette
and
RETRY.
If after 3 or
4 retries, the system
still does not
accept
the
WORKBENCH
diskette,
try a
DIFFERENT copy of the
disk.
•
If the
disk
STILL
WILL NOT
LOAD, refer
to 1 .7
DRIVE
ASSEMBLY
CHECK.
OR
•
if the
drive
was
previously tested as OK,
EXCHANGE
THE
RAM
EXPANSION
CARTRIDGE
and
RETRY.
When loading is
complete,
the
screen will be blue
with
the
WORKBENCH
DISK
ICON in the
upper
right hand
corner. The
TITLE
BAR message
will be;
Amiga
Workbench
Version
1,0
429928 free
memory,
1-13