Amiga 1000 - Page 8

AMIGA
1000 ASSEMBLY
LEVEL REPAIR
NOTE:
WRiTE-PROTECT
ALL
VOLUME
DISKS
BEFORE
BEGINNING!
•
Slide the
write-protect tab
up toward the edge
of the
disk
to
expose the
small
hole in
the disk
case.
1.6
SYSTEM
DRIVE
TEST
1.6.1
Insert
the
diskette
labeled
KICKSTART into the
interna*
drive.
At this
time, the
screen
should
turn white as the
system
loads
the disk.
The drive
activity
light will
flash
briefly and the
drive
access
sounds
should
be
heard. After
approximately 30
seconds and
some
screen
changes,
the
system
should
display a
hand
holding
a
diskette
labeled
WORKBENCH.
•
If the
hand
holding
the
diskette
labeled
KICKSTART
REAPPEARS, re-seat
the
diskette and
RETRY. If
after 3
or 4 retries,
the
system
still does not accept
the
KICKSTART
diskette, try
a
DIFFERENT
COPY of the
disk.
•
If the disk still
WILL
NOT
LOAD, continue
to
1.7
DRIVE
ASSEMBLY
CHECK.
1.6.2
Remove the
KICKSTART
disk.
1.6.3 Insert the
diskette
labeled
WORKBENCH into the
internal
drive.
At this
time, the
screen
will turn
white
for
approximately 2
seconds
and then
display the
boot-up
message
while
continuing to
load from
the disk.
•
If the hand
holding
the
diskette
labeled
WORKBENCH
REAPPEARS,
re-seat
the
diskette
and
RETRY. If
after 3 or
4 retries, the
system
still
does
not
accept
the
WORKBENCH
diskette,
try a
DIFFERENT copy of the disk.
•
If
the disk
STILL
WILL NOT
LOAD,
continue to 1.7
DRIVE
ASSEMBLY
CHECK.
When loading is
complete,
the screen wil! be
blue with the
WORKBENCH
DISK
ICON
in the
upper right hand
corner.
The
TITLE BAR
message
will be:
Amiga
Workbench
Version
1 .0 167840
free
memory
1.6.4 Select
the
WORKBENCH
ICON
with the
mouse.
With the
mouse,
move the
pointer on to
the
ICON and
click the
left
button
once. The
ICON
will turn black
to
indicate it
has been
selected.
1.6.5
Select
DUPLICATE
from the
menu.
Press
and
hold the
right mouse
button while
sliding the
pointer to
the
upper
left
corner of
the
title bar.
When the
pointer
is
over the
word
Workbench, the
word
will
highlight and the
menu
selection
will be
displayed.
Continue
to
depress
the right mouse
button and
slide the
pointer
down
to
the
word
DUPLICATE
and,
when
DUPLICATE
is
highlighted,
release the right
mouse
button.
The
DISKCOPY
WINDOW
will be
displayed and
will
continue to
prompt
you
through
the
en-
tire
DISKCOPY
procedure.
1-6