Need help?Do you have a question about the Amiko Multi Tracker 2 and is the answer not in the manual?
General| Brand | Amiko |
|---|---|
| Model | Multi Tracker 2 |
| Category | Measuring Instruments |
| Language | English |
Signal input port and the device's display screen.
Lights indicating charging status and LNB connection warnings.
Keys for device operation, menu navigation, and parameter adjustment.
Procedures for charging the meter and resetting its functions.
Steps for measuring satellite signals.
Steps for measuring terrestrial signals.
Steps for measuring cable TV signals.
Submenu for DVB-S/S2 system functions.
Submenu for DVB-T/T2 system functions.
Submenu for DVB-C system functions.
Submenu for system parameters like language, auto power off.
Shows signal strength, quality, BER, CNR, modulator type, FEC, and power level.
Set LNB type, power, 22k, DiSEqC type, and motor type.
Set satellite, longitude, latitude for USALS alignment.
Control motor movement for DiSEqC 1.2 positioning.
Edit satellite name, orbit position, and transponder parameters.
Displays the spectrum chart of the setting frequency range.
Shows constellation diagram for signal quality analysis.
Calculates elevation and azimuth for antenna alignment.
Checks output status of Quattro LNB ports.
Shows SNR, CBER, VBER, power, strength, and quality.
Scans saved frequencies and shows lock status.
Displays the spectrum chart of the setting frequency range.
Shows 6 channels level (dBuV) in one page.
Lists all locked frequencies found during Auto Scan.
Configures antenna power supply and scan settings for DVB-T/T2.
Shows SNR, PBER, PER, power, strength, and quality.
Shows tilt of three channels' power level.
Analyzes the spectrum of the cable TV signal.
Controls beep status during key presses or signal lock.
Sets the time for the meter to enter standby mode automatically.
Selects the user interface language.
Resets the meter to factory default settings.
Shows the version number of the hardware.
Shows the version number of the software.
Charge meter until light turns blue for power-on issues.
Check antenna overload and signal cable if warning LED flashes.
Press the reset button to reset the meter if it hangs up.
Confirm cable connection and antenna power for signal lock problems.
Contact your local dealer for any other technical questions.
To Next Page