TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS - 27 -
5.2 Handling and positioning
The appliance must be placed on a stable and level surface.
Ensure that, from the point of view of the overall dimensions (see Table 1 - Section 9), the space
provided for the appliance allows its correct use and easy servicing as indicated in section 6.
ATTENTION!
Remove the appliance from the packaging, be sure to follow the instructions in section 4 (En-
vironmental notes) with regard to the storage and disposal of the packaging materials;
While always keeping the appliance level, move and position it on a stable and correctly lev-
elled surface.
In order to avoid damage to the compressor and cooling system, never tilt the
appliance more than 45° during transport and positioning. After transport or han-
dling, wait at least 4 hours after the appliance has been positioned before switching
it on. This will allow the compressor oil to level and prevent it from entering the
cooling circuit, causing irreversible damage to the compressor and the evaporator.
Never place the appliance on a flammable surface (e.g. carpet, rugs, tablecloths, etc.);
Do not position the appliance near open flames, electric cookers, ovens or other sources of
heat, such as, for example, places exposed to direct sunlight. Heat can damage the surface of
the appliance and adversely affect its operation;
Position the appliance so that the all sides are always at least 10 cm from walls, furniture and
other objects. This is to ensure good air circulation and easier access to all parts of the appli-
ance as well as to provide the necessary space for its operation;
The appliance must not be built into furniture or masonry walls;
Do no drill holes into the appliance or attach objects to it;
The appliance must not be used if it is out of order, damaged or has suffered impacts;
To avoid hazardous situations for the user do not use accessories or spare parts, which differ
from those recommended by the manufacturer. The appliance could be damaged or prove to
be a risk for the health and life of individuals.
ATTENTION! If incorrectly positioned, the appliance is not enabled for operation.
5.3 Use
Clean the appliance before its first use (see section 6 - Cleaning and servicing). Carefully clean
the GN pans too, before use them;
Open the sliding door on the operator side and place the GN pans on the surface inside the
appliance;
Insert the plug into an individually interlocked protected electric socket in compliance with the
regulations;
Only put sushi in the GN pans inside the appliance after it has reached the operating tempera-
ture set on the control unit (see paragraph 5.4 - Operation).
To Next Page
Loading...