EasyManua.ls Logo

AMOT G Series - Safety; Maintenance; Product Support; Typographical Conventions

AMOT G Series
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Introduction
Rev 4 – MAY 2019 OMMGGE00217
1.2 Safety
Certain operations within this manual are potentially hazardous and could
cause injury to personnel or damage to equipment if the instructions are not
carried exactly as described. Where a significant, potential hazard exists, the
following text appears immediately before steps in the procedure that present
a particular hazard:
WARNING
A Warning identifies a hazard that could cause injury to personnel.
The text of the warning describes the hazard and details the
precautions that must be applied before the next step of the procedure
is carried out.
CAUTION
A Caution identifies a hazard that could cause damage to equipment.
The text of the caution describes the hazard and details the
precautions that must be applied before the next step of the
procedure is carried out.
Note
A Note contains supplementary information that may be useful to the
Operator before the next step of the procedure is carried out.
1.3 Maintenance
Maintenance of the valve and actuator should only be carried out by suitable
trained and competent persons, and only after they have read and understood
all applicable sections of this manual. Failure to observe this may result in
damage to equipment or to injury of personnel.
1.4 Product Support
All necessary settings and, where appropriate, alterations inside the equipment
are described in this Operating Manual. If any difficulties arise during start-up,
you are asked not to carry out any unauthorised actions on the unit. You could
endanger your rights under the equipment warranty.
For spares and service support, call the telephone number listed on the back
cover of this Manual.
1.5 Typographical Conventions
Footnotes
Where space in the text or figures to place a note is restricted, a footnote is
used. They consist of two parts:
A mark indicating which part of the text or figure is affected by the note.
This takes the form of a superscript number e.g. Abc
1
.
1
This footnote applies to the part of the text or figure, marked with a superscript number 1.

Table of Contents

Other manuals for AMOT G Series

Related product manuals