1 About This Manual
1.1 Introduction
This manual contains all the information required to install, commission and operate the FireFinder
SERIES II Fire Alarm Control Panel (FACP) fitted with Version 6 software and is only available to
and for the use of personnel engaged in its installation, commissioning and operation.
1.2 General Requirements
The FireFinder Series II FACP has been designed and manufactured from high quality commercial
components so as to comply with major world standards. To ensure these standards are not
compromised in any way installation staff and operators should;
Be qualified and trained for the task they undertake;
Be familiar with the contents of this manual prior to the installation, commissioning or
operation of a FireFinder control system;
Observe anti-static pre-cautions at all times; and
Be aware that if a problem is encountered or there is any doubt with respect to the
operational parameters of the installation the supplier should be contacted.
1.3 References
FireFinder Technical Manual
ConfigManager
FireFinder Detector Manual
National Standards:
Singapore CP10: 2005
Malaysia: MS1404: 1996
1.4 Symbols
Important operational information
Note: Configuration considerations
Observe antistatic precautions
Mains supply earth
DANGER mains supply present
To Next Page
Loading...
Need help?
General
