Ampac LoopSense MAN 1572-4 User Manual

Page 39
LOOPSENSE EN54 USER MANUAL
EDIT POST-DELAY: 0 (0-999 seconds)
#CLEAR
◄BACK NEXT►
Press NEXT► to go to the next field.
The user is then prompted to save any changes that may have been made.
7.6.3.3 Menu->Programming->Panel->Loop
SELECT LOOP: X
<selected loop descriptor>
►L1 L2
If there is more then one loop the user is prompted to select the loop using the generic loop selection
screen.
EDIT DESCRIPTOR
LOOP 1_
#CLEAR DEL▲
◄BACK NEXT►
Press enter to edit the selected Loop configuration settings.
LOOP X TERMINATION: SINGLE-ENDED
CHANGE▼
◄BACK NEXT►
Press NEXT► to go to the next field.
The user is then prompted to save any changes that may have been made.
7.6.3.4 Menu->Programming->Panel->Descriptor
EDIT CUSTOM BANNER 1
AMPAC TECHNOLOGIES PTY. LTD._
#CLEAR DEL ▲
◄BACK NEXT►
The user may modify the two descriptors displayed on the normal screen
EDIT CUSTOM BANNER 2
LOOPSENSE (C) 2008_
#CLEAR DEL ▲
◄BACK NEXT►
Press NEXT► to go to the next descriptor.
The user is then prompted to save any changes that may have been made.
7.6.4 Menu->Programming->Sounders
SOUNDER MENU
1►GLOBAL ACTIVATION
2|ZONE ACTIVATION
This menu allows programming of the Zone and Global activation settings for sounders.
7.6.4.1 Menu->Programming->Sounders->Global Activation
GLOBAL <action type>
ACTIVATION MODE: EVACUATE
CHANGE▼
◄BACK NEXT►
The activation mode for each Global action type can be selected.

Ampac LoopSense MAN 1572-4 Specifications

General

Brand	Ampac
Model	LoopSense MAN 1572-4
Category	Control Panel
Language	English