EasyManua.ls Logo

Amped Wireless SR10000 - Page 46

Amped Wireless SR10000
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SR10000
USER’S GUIDE
45
45
I am connected to a Home Network however I do not have Internet Access.
a. The Home Network itself may not have Internet access. Check to see that you have internet access by
connecting directly to the Home Network first. If you are able to go online then this is not a problem.
If you cannot go online, then the Home Network’s Internet connection must first be resolved.
b. You may have a DNS issue and the Smart Repeater is not obtaining the IP settings from your Home
Network. Try to reboot the Smart Repeater and then accessing a website. If that fails, then reboot
the Home Router to see if that fixes it.
c. There may be an IP conflict with your Home Network and your Extended Network. Try to adjust the
IP Settings of your Extended Network using IP values that are different from your Home Network.
I can no longer connect to the Smart Repeater wirelessly.
a. Power on and off the Smart Repeater and try again.
b. The connection to the Home Network may be down. Use an Ethernet cable and connect directly to
the Smart Repeater. Access http://setup.ampedwireless.com and run through the Smart Setup
Wizard again. After you have successfully reset the Home Network connection, try connecting
wirelessly again.

Other manuals for Amped Wireless SR10000