I could NEVER log onto the Smart Repeater wirelessly.
a. Check that your wireless adapter supports WPA2 wireless security. If it does not then you will need to
change the wireless security on the Smart Repeater. Go to the Web Menu, select Wireless Settings
and then Wireless Security. Select the Extended Network from the drop down menu and either
disable security or downgrade the security to WEP. Try connecting again.
b. The connection to the Home Network may be down. Use an Ethernet cable and connect directly to
the Smart Repeater. Access http://setup.ampedwireless.com and run through the Smart Setup
Wizard again. After you have successfully reset the Home Network connection, try connecting
wirelessly again.
I can no longer access the Web Menu or the Smart Repeater no longer responds.
a. Connect to your Smart Repeater and try to access http://setup.ampedwireless.com using your web
browser.
b. If you are advanced in networking troubleshooting, log onto your home router’s web interface. Look
for the DHCP client list and try to find the IP address of your Smart Repeater assigned by your home
router. Once you have it, connect to the Smart Repeater using an Ethernet cable. Open your web
browser and enter the IP address into the address bar.
To Next Page
Loading...
