15
D-0126050 rev 1 - 270+ Operating Manual
2.8. THE SANIBEL MPT-II PRINTER
2.8.1. INSTALLING THE SANIBEL MPT-II PRINTER
The Sanibel MPT-II thermal printer is available as an option for use with the 270+ and is connected using the
cable supplied. The printer may be specified when ordering and only this printer should be used. It will be
correctly configured for use.
1. Open the lid by pushing on the sides, insert paper roll as shown,
2. and close the lid.
2.8.2. SWITCHING THE PRINTER ON AND OFF
Push POWER BUTTON for two seconds in order to power ON or OFF. One
short beep will be heard at power ON, two short beeps at power OFF.
The green power indicator will be lit if the printer is powered by battery.
While printer is powered OFF, press and hold PAPER FEED button, then press
and hold POWER BUTTON simultaneously. When beep is heard after approx. 3
seconds, release both buttons, and a test page will print with information on current
status and character samples.
When powered, press PAPER FEED button. Paper will feed as long as the button
is pressed.
• Connect the printer via the cable with the device
• Power on printer
• Select print option in 270+
Please note: Do not have several printers powered on and within range while
searching.
To Next Page
Loading...
Need help?
General
