26
D-0126050 rev 1 - 270+ Operating Manual
To LOAD the stored set of audiogram thresholds, select the location slot (1-10) under which the data is stored
(F1) and press F2 (SAVE). Select CANCEL (F4) or the MENU button again to leave the menu without changes.
4.7.4. PRINT
The Sanibel MPT-II is the designated thermal printer to be used with the 270+. Learn more about the MPT-II
printer in chapter 2.8. When using the printer, ensure it is switched on and ready to print.
The printed audiogram will be the current shown threshold, which had either just been recorded or loaded from
the internal memory. Select PRINT in the MENU.
As soon as the printer is ready, select the F1 key to confirm. The audiogram will then print.
To Next Page
Loading...
Need help?
General
