Amprobe ACD-10 TRMS-PLUS - General Specification

10

3-3/4 digits 4000 counts LCD display
3 per second nominal
Automatic
0 °C to 40 °C; < 80% RH for temperature up to 31 °C
decreasing linearly to 50% RH at 40 °C
Operating below 2000m; Indoor use
-20
o
C to 60
o
C, < 80% RH (with battery removed)
nominal 0.15 x (specified accuracy)/
o
C @(0
o
C ~ 18
o
C or
28
o
C ~ 40
o
C)
Below approx. 2.4V
3V coin battery IEC-CR2032
2.8 mA typical except that 3.3 mA typical for ACA function
Idle for 30 minutes
5 μA typical
190 x 63 x 32 mm (7.4 x 2.5 x 1.3 in)
139 gm approx
max 26 mm
Test leads, battery installed, user’s manual, & soft carrying pouch;
30ms Max Hold; Data Hold; Relative Zero mode
Meets EN61010-2-032, UL61010B-2-032, IEC61010-1 2
nd
Ed., EN61010-1
2nd Ed., UL61010-1 2nd Ed. CAT III-600 Volts ac & dc; Pollution degree : 2
 Conforms to EN61326-1.
This product complies with requirements of the following European Community
Directives: 89/ 336/ EEC (Electromagnetic Compatibility) and 73/ 23/ EEC (Low
Voltage) as amended by 93/ 68/ EEC (CE Marking). However, electrical noise or
intense electromagnetic fields in the vicinity of the equipment may disturb the
measurement circuit. Measuring instruments will also respond to unwanted
signals that may be present within the measurement circuit. Users should exercise
care and take appropriate precautions to avoid misleading results when making
measurements in the presence of electronic interference.