Press down the key marked [CTRL] (Control), and AT THE SAME TIME press the small [ENTER]
key at the bottom right of the number-only keypad next to the Datacorder. The screen will respond
with the instructions:
RUN"
Press PLAY then any key:
Now press the [PLAY] key in the row at the front of the Datacorder until it locks down firmly,
followed by pressing any letter, number, or either [ENTER] key - or the space bar.
The tape will start to move, and after a short time you will see this message appear on the screen:
Loading WELCOME block 1
The tape will take approximately 5 minutes to load, you can see this happening on the screen since
‘block’ number will change to 2,3 etc., until the tape stops. At this time the ‘Welcome’ program will
begin to run. Just sit back and watch. The program runs continuously, so when you have finished
watching press the [ESC] key twice. This stops the program and you can now [STOP] and eject the
cassette, then turn it over to run side two.
After turning the cassette over ready for Side 2, once again remember to press the [REW]ind button
on the datacorder to ensure that the tape is rewound to the start.
Press down the key marked [CTRL] (Control), and AT THE SAME TIME press the small [ENTER]
key at the bottom right of the number-only keypad next to the Datacorder. The screen will respond
with the instructions:
RUN"
Press PLAY then any key:
Now press the [PLAY] key in the row at the front of the Datacorder until it locks down firmly,
followed by pressing any letter, number, or either [ENTER] key - or the space bar.
The tape will start to move, and after a short time you will see this message appear on the screen:
Loading WELCOME 2 block 1
Follow the instructions given on the screen, and the program will invite you to participate by typing
instructions as it progresses.
To Next Page
Loading...
