To Next Page

To Previous Page

Upgrading Firmware

MXD/T-701 7" Modero X Series® G5 Touch Panels

In this case, there are two options for proceeding with the firmware transfer:

Select Transfer the KIT File via the NetLinx Master Controller (legacy KIT file transfer method)... to

proceed using the standard (non-HTTP) method used for other NetLinx Devices (via the master controller)

when OK is clicked.

Note that depending on network speed and the size of the *.kit file, this method could take up to 20-30

minutes to complete. More specifically, timed tests indicate that it takes approximately 60 seconds per 9.5MB

of a *.kit file to transfer. The following table indicates the approximate length of time to send a *.kit file via

the legacy file transfer method:

By default, Change the HTTP Port used to transfer the KIT file... is selected. Use this option to change the

HTTP port assignment, in cases where the IP port (default = 80) is in conflict or blocked on the PC. This

option will restart the web server with a different HTTP port assignment and restart the file transfer when OK

is clicked.

Select the appropriate option and click OK to restart the file transfer.

Click Cancel to cancel the current file transfer.

FIG. 32 NetLinx Studio v3.4 or higher - HTTP Server Error dialog

File Size Time Required to Complete Transfer (legacy file transfer method)

0-150MB 10 - 15 minutes

150-200MB 15 - 20 minutes

200-250MB 20 - 25 minutes

250-300MB 25 - 30 minutes

300-350MB 30 - 35 minutes

>350MB > 35 minutes

Other manuals for AMX MXT-701

Questions and Answers:

Need help?

Do you have a question about the AMX MXT-701 and is the answer not in the manual?

General