What to do if all lights stay on with my AMX Controller?
If all lights stay on when using your AMX Controller, you should check the dimmer DIP switch settings. Additionally, try disconnecting and then reconnecting the AXlink or RS232 control.
Why does the panel LED stay on on my AMX Controller?
If the panel LED stays on with your AMX Controller, verify the PROlink wiring, the Pack number, and the dimmer Pack settings.
What to do if my AMX Controller has no operation?
If your AMX Controller shows no operation, the first step is to check the PROlink wiring.
What to do if Up and Down arrows do not work in Preset Recall Mode on my AMX Controller?
If, in the Preset Recall Mode, Presets can be recalled, but Up and Down arrows do not work on your AMX Controller, check the Pack numbers. Verify that Packs are set for 1 and 2.
How to fix AMX Controller when I cannot select zones 1-12?
If you cannot select zones 1 - 12 on your AMX Controller, check the Pack number and mode settings.
How to fix erratic fading presets on my AMX Controller?
If the presets on your AMX Controller fade erratically, check the phasing.
General| Brand | AMX |
|---|---|
| Model | PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL |
| Category | Controller |
| Language | English |
Instructions for preparing the PRO-DP8 panel and its associated dimmer control cards for installation.
Provides instructions and guidelines for wiring the PRO-DP8 panel using PROlink connectors and cables.
Step-by-step guide on connecting the PRO-DP8's PROlink connector to dimmer Packs for data and power.
Provides steps to test the PRO-DP8 panel after installation to ensure proper operation and communication.
Offers solutions to common installation problems encountered with the PRO-DP8 panel.
Details the operational assignments and functions of the 8 DIP switches located on the back of the PRO-DP8 panel.
Explains how to use DIP switches 1-3 to set offset values for panel pushbuttons, affecting preset numbering.
Describes how DIP switches 4 and 5 determine which dimmer Packs (1-3) the PRO-DP8 panel communicates with.
Explains how DIP switch 7 controls panel behavior between Preset Recall and Zone Select/Ramping modes.
To Next Page