DIP Switch Configuration
18
PRO-DP8 Decor 8-Button Wall Panel
Using Switch 7 to Enable Either Preset Recall mode, or
Zone Select/Preset Ramping
Panel pushbutton 5 (Select buttons) has two possible functions, depending on the setting of DIP
switch 7. DIP switch 7 enables/disables the panel’s ability to select zones, or recall presets.
! Set switch 7 to Off (factory default setting) to enable Zone Select mode, and allow
ramping of light levels. In this mode, pushbuttons 6 and 7 function as Up and Down
buttons for ramping a selected preset.
! Set switch 7 to On to disable preset ramping. In this mode, pushbuttons 6 and 7 recall
Presets instead of ramping presets.
Using Switch 8 to Enable/Disable Program Mode
DIP switch 8 determines if the panel has the ability to enter Program mode, which allows you to
program lighting scenes, and store them as programmed Presets.
! Set switch 8 to Off (factory default setting) to enable programming of preset levels and
fade times.
When preset programming is enabled, press pushbuttons 6 and 7 simultaneously to enter
Program Mode. The P (Program) LED lights when this mode is active.
! Set switch 8 to On to disable the programming function. When Program mode is
disabled, panel pushbuttons 6 and 7 do not allow the panel to enter Program mode.
To Next Page
Loading...
