AMYET S6 - Page 23

AMYET S6 E-BIKE
21
NOTE ON USAGE
Battery installation/mounting
Before you charge
To install the battery, you do need the key. Check to ensure the battery mount is clean and
dry, and then follow these steps.
Always charge in a safe, dry, indoor area that is away from children, direct sunlight, dirt,
debris, tripping hazards (including electrical cords), or any materials that could ignite in
the unlikely event of a charger or bat- tery malfunction. Arrange the bike, battery, and
charger to eliminate the potential for falls or other impacts. Make sure you stay close
enough to it to check on it occasionally.
NOTICE: Failure to follow the battery-charging best practices outlined in this manual
could result in unnecessary wear to the battery and/or charger, and could lead to an
underperforming or non-functional battery. Batteries damaged due to improper care will
not be replaced under warranty.
Where to charge
Make sure the battery, charger, and electrical cables show no signs of damage. The termi-
nals on the battery and its mount should be free of dirt, rust, corrosion, and leakage.
Check the condition of your battery and charger
For best charging performance and to minimize wear and tear on components, we recom-
mend charging at ambient temperatures of 5°C to 25°C (41°F to 77°F). Your battery gener-
ates heat while charging, but it’s designed to air-cool, so keep it uncovered with the light
facing upwards on a flat, stable, hard, unheated surface. At relatively low temperatures,
charging can take longer.
Ensure the ambient temperature is appropriate
OPERATION:
Recommended temperature range
77°F
(25℃)
41°F
(5℃)
F
C
-20°
0° 10° 20° 30° 40° 50° 60° 70° 80° 90° 100° 110° 120° 130° 140°
-10° 0° 10° 20° 30° 40° 50° 60°
100°F
(38℃)
!!