AMYET S6 E-BIKE
22
CHARGING PROCEDURE
CAUTION: Do not charge your battery when it is warm from riding or in ambient
temperatures above 38°C (100°F) to prevent unnecessary wear and tear on battery
and charger. If the battery has turned off to prevent heat damage, wait until the
battery cools down to turn the battery back on. Never charge your battery on or near
heat-generating devices.
Store any damaged or potentially damaged battery or charger in a safe, dry location away
from the house and other flammable materials/structures and, as soon as possible, recycle
or otherwise dispose of it according to local rules.
Using a damaged battery or charger can damage additional components or create a fire
hazard. Stop using your battery and charger and contact AMYET if any of the following
occur:
(1) your charger’s flexible power cord or output cable or any of the electrical cables on
your ebike/etrike is frayed, has broken insulation, or any other signs of damage
(2) your battery or charger is physically damaged, non-functional, or performing
abnormaly
(3) your battery or charger experienced a significant impact from a fall, crash, or shipping
damage, with or without obvious sighs of damage
(4) your battery was submerged in liquid or had extensive water exposure or damage, or
(5) your charger becomes too hot to touch (it’s designed to get warm with normal use),
make an unusual smell, makes a popping sound, or shows other structures and, as soon as
1.Turn the power off. Press and hold the power button on the UI Remote until the display
turns off. If desired, use the key to unlock and remove the battery from the ebike frame.
The battery can be charged either on or off the ebike.
2. Locate the charging port of the battery. The charging port is on the same side of the
battery as the keyport. Note that the charging port includes a cover; the keyport does not
have a cover.
3. Place the charger on a flat, secure surface if you have removed it from your ebike. The
charging indicator light should face up.
4. Plug the charger into the battery charging port. Open the flexible cover on the charging
port. Connect the charger’s round barrel connector to the charging port on the side of the
battery.
5. Plug the charger into a power (wall) outlet. Charging should initiate and will be indicated
by the LED on the charger turning green (to indicate power source connection) and then
immediately turn red to indicate active charging. When charging is complete, the LED will
turn green again.
!
To Next Page
Loading...