AMYET S6 E-BIKE
24
INSPECT
1.Check the chain for stretch to make sure there is no noise or loosening.
2.Check spoke tension and the trueness of the wheels, , and check for quiet wheel
operation (without spoke noise).
3.Check all bolted connections for loosening and ensure they are tightened.Ensure all
the parts that need to be tightened have been correctly tightened,such as frame, handle-
bar, seat post, etc.
4.Check brake pad wear, alignment, and the brake lever tension. The distance between
the brake lever and the handlebar must be at least 15mm when you press the front and
rear brake lever to completely stop the wheels.
5.Look out for any loose cables.Make sure that every male and female plug is properly
connected.There should be no strain on any wiring near the fork when turning the
handlebars from left to right.Verify that the wiring on the frame is secure and free from
any moving parts that may damage the wiring. This includes any wires and brake cable
lines near the wheel or other moving parts.
6.Check that the battery is inserted securely.Push the battery into its holder until it
clicks into the lock. Remove the key from the lock and pull the battery to check if it has
indeed locked into place.
Certain components can stretch or loosen during any bike or ebike’s break-in period,
which can lead to component failure and potential injury or death. Be sure to have a
professional, reputable bike mechanic perform a thorough tune-up after this break-in
period or sooner if you notice any problems or if you ride aggressively, with heavy
payloads, or in harsh conditions.
WARNING: Using aftermarket accessories or components (trailers, stands, vehicle
racks, etc.) that have not been tested by AMYET for safety and compatibility with your
specific ebike may void your warranty, create an unsafe riding condition, result in
ebike/property damage, or cause serious injury or death. If you use replacement parts
or accessories not tested and recommended by AMYET, you do so at your own risk.
!
To Next Page
Loading...