AMYET S6 - Page 8

AMYET S6 E-BIKE
6
4.Install the front fender/mudguard
B.Put the fender in the position of the front fork,insert the bolt into it,and then lock the
nut, fix the nut with a wrench, and tighten the bolt with a hexagonal screwdriver.
A.Pass the fender from the back of the front wheel.
5.Install the pedals
6.Inflate the tyres
7.Prepare your ebike’s power system for use
B.The right pedal is screwed on in a clockwise direction. The left pedal is screwed on by
turning it counter-clockwise.
A.Install and tighten the pedals using the 15 mm open wrench. Look for a letter marking
“L” “R” on each respective pedal and make sure you install the left pedal on the left crank,
and the right pedal on the right crank.
A B
A B
E F G